Wilson Antennas

 

 

FGT Fiberglass Series

  Adjustable tip for fine tuning SWR & resonant frequency

 Exclusive impedance matching transformer lead

 3/8" fiberglass rod for heavy duty performance, 1/4" tapered fiberglass rod on Flex

Fully linear top loaded for maximum transfer of power out of antenna (better than helical winding)

  Spaced windings to reduce dielectric heat loss

  18 gauge silver plated wire to reduce resistive losses on FGT, 22 gauge on Flex

  PVC protective covering around antenna on FGT, special rubberized covering on Flex.

  Static reducing weather cap

  3/8" X 24" standard threaded mounting

FGT-4   4' Whip   $32.99   
Select A Color


BACK   TOP

 

Trucker 2000

 The Wilson 2000 Trucker’s higher gain performance is a result of several new design developments that bring you the most powerful CB center loaded antenna available in its price range.

A large portion of the power that goes into a typical loaded CB antenna is lost as heat in the coil and as dielectric heat loss in the plastic inside the coil form. Many CB antennas lose more than 50% of the power put into them. The power is wasted as heat loss and is not radiated as radio waves. Another weak link in other CB antennas is the capacitor used to match the coax to the antenna. This is a cheap and easy way to make the SWR look good, but has lots of power loss, plus blows out when high power is applied to it.

The first priority was to reduce the dielectric loss by removing as much of the plastic inside the coil as possible. This was accomplished by suspending the coil in air, supported only at four small points, 90 degrees apart, in effect removing 95% of the plastic from the inside surface of the coil. This reduced the dielectric loss to a negligible amount.

The second priority was to get rid of the resistive heat loss in the coil. Since most of the RF energy at 27 MHz travels on the surface of the wire, it was decided to increase the surface area by making the diameter of the wire a larger 10 gauge copper. Since silver is a much better conductor than copper, although very expensive, the wire was heavily silver plated. This reduced the resistive loss to a minimum. Any power loss in the coil is practically eliminated in the Wilson 2000 Trucker.

So far you have read about why the Wilson Trucker 2000 performs better, but it is also the most rugged trucker antenna you can buy. It is made with Mobay’s Thermoplastic which costs a lot more, but it’s the best available.

Features

  Uses Silver Plated 10 gauge, Solid Copper Wire
outperforms copper, nickel, & chrome plating

  Easily Handles 3,500 Watts

  Large coil housing for increased power handling

  Exclusive low loss coil design (Patent #4,882,591)

  Made From High Impact Engineering Thermoplastics

  Frequency Range: 26 MHz to 30 MHz

  5"  Stainless Steel Shaft

  49" 17-7 spring stainless steel whip

  Can be used as a single antenna or co-phased for dual antennas

  3/8" X 24" Standard Threaded Shaft


Trucker 2000
         $67.99

Select A Color

BACK   TOP

 

Trucker 5000

The Trucker 5000 was designed specifically for users who want the best in a high performance antenna with the ability to withstand some serious power. The Wilson 5000 Trucker handles 5000 watts AM, 20,000 watts SSB (ICAS rating).

Wilson’s attention to detail, engineering quality and designs are what helps make the antenna perform so well. The strength of performance and power handling capabilities of the antenna will prove themselves the first time extra power is needed to break through noise and congestion on the air.

     3/16" Solid Copper Silver Plated Wire
     High Power Ability To Handle 5,000 Watts AM, 20,000 Watts SSB
     Absolute Floating Coil Eliminates 95% of Dielectric Loss
     Cover Made From High Impact Engineering Mobay Thermoplastics
     Frequency Range: 26 MHz to 30 MHz
     49" Tapered Spring Stainless Steel Whip
     10" Stainless Steel Shaft
     Solid 3/8" Stainless Steel Shaft - Will Not Break
     3/8" X 24" Standard Threaded Shaft


Trucker 5000
         $82.99

Select A Color

 

BACK   TOP

 

Little Wil

     300 Watt power handling capability (ICAS)
     Made with high impact Thermoplastic
     Heavy duty coil uses 14 gauge copper wire
     Exclusive low loss coil design (Patent #4,882,591) - Same as Wilson 1000
     36" 17-7 PH stainless steel whip
     Frequency range 26 MHz to 30 MHz

Little Wil         $37.99


BACK   TOP

 

 

Home

Antennas

Microphones

Customs

Wiring Diagrams

Helpful Links

CB Radios

Cables/Mounts

Satellite

Accessories

Tech Support

Repairs/Upgrades

Policies

Contact Us

Free Website Hit Counter Codes by http://webdevelopmenttutorials.com
web hosting reviews